Hypertherm Powermax vs. Hypertherm MAXPRO
Max Pro overview:
- Faster cut speeds by over 40% on average vs Powermax
- Increased cutting capacity – pierce up to 32mm mild steel and edge start up to 50mm
- Less taper in small holes by on average 1mm less
- Significantly less dross. Up to 20mm dross free cutting
- Improves consumable life by three times, according to Hypertherm
- Due to improved consumable life you will see better repeatability over a larger quantity of parts
- Multi Gas cutting, ability to cut with 02/air on mild steel for improved edge finish – leaves weld ready, edge decreasing, plate preparation time
Powermax overview:
- Cutting capacity up to 25mm thickness
- Lower initial investment to Max Pro at almost half the cost
- Improved quality on thinner material – 3mm and below
- Cheaper to run when cutting lower volumes
- Easier to operate
