Hypertherm Powermax vs. Hypertherm MAXPRO

Max Pro overview:

• Faster cut speeds by over 40% on average vs Powermax
• Increased cutting capacity – pierce up to 32mm mild steel and edge start up to 50mm
• Less taper in small holes by on average 1mm less
• Significantly less dross. Up to 20mm dross free cutting
• Improves consumable life by three times, according to Hypertherm
• Due to improved consumable life you will see better repeatability over a larger quantity of parts
• Multi Gas cutting, ability to cut with 02/air on mild steel for improved edge finish – leaves weld ready, edge decreasing, plate preparation time

 

Powermax overview:

• Cutting capacity up to 25mm thickness
• Lower initial investment to Max Pro at almost half the cost
• Improved quality on thinner material – 3mm and below
• Cheaper to run when cutting lower volumes
• Easier to operate